Maintenance Schedule; Residual Risk - Ryobi RCS3835T Traduction Des Instructions Originales

the chain drive links into the bar groove. If needed,
rotate the chain tension assembly to apply some
tension to the chain which will help keep it in place.
10. Replace the sprocket cover.
11. Adjust the chain tension. Refer to the "Adjusting the
chain tension" section.
CLEANING THE AIR FILTER
See page 290.
1. Stop the product. Make sure the chain brake is in the
brake position.
2. Unscrew the locking knob on the air filter cover and
remove it from the product.
3. Remove the air filter.
4. Remove the dust and dirt on the air filter with a brush.
If necessary, split the air filter with a flat blade screw
driver and clean the inside.
5. Replace the air filter cover and tighten the locking knob.
CLEANING THE SPARK ARRESTER
See page 291.
WARNING
The silencer is hot during and after operation of the
product. To avoid serious personal injury, keep all body
parts away from the silencer during and after operation.
1. Stop the product. Make sure the chain brake is in the
brake position. Allow the silencer to cool.
2. Remove the screw holding the silencer cover to the
spiked bumper, then remove the two nuts on the
silencer cover.
3. Remove the silencer cover.
4. Take out the spark arrester. Clean the spark arrester
screen with a small wire brush.
5. Replace the silencer cover. To replace the silencer
cover, redo these steps in reverse order.
WARNING
The spiked bumper is a safety feature on the product.
Secure it with the correct screw after replacing the
silencer cover. Failure to follow this instruction may
result in serious personal injury or death.
INSPECTING AND CLEANING THE CHAIN BRAKE
See page 294.
Always keep the chain brake mechanism clean by
lightly brushing the linkage free from dirt.
Always test the chain brake performance after cleaning.
Refer to "Operation - Checking and Operating Chain
Brake" earlier in this manual for additional information.
8 | English
ENGINE SPEED AND CARBURETTOR ADJUSTMENT
WARNING
Incorrect carburettor adjustment may increase the
risk of injuries, fatal accidents, or product damage.
For carburettor adjustment, bring the product to an
authorised service centre.

MAINTENANCE SCHEDULE

Daily check
Fuel mixture
Bar lubrication
Chain tension
Clutch engagement
(no chain movement at idling
speed)
Chain sharpness
For damaged parts
For loose fasteners
For loose parts
Chain brake function
For fuel leaks
INSPECT AND CLEAN:
Bar
Complete saw
Air filter
Chain brake
Replace spark plug
Replace fuel filter
* Hours of Operation

RESIDUAL RISK

Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise in use and the
operator should pay special attention to avoid the following:
Injury caused by vibration. Always use the right tool for
the job, use designated handles and restrict working
time and exposure.
Exposure to noise can cause hearing injury. Wear ear
protection and limit exposure.
Contact with exposed saw teeth of the chain (cutting
hazards).
Unforeseen, abrupt movement or kickback of the guide
bar (cutting hazards).
Parts ejected from the saw chain (cutting/injection
Before each use
Before each use
Before each use
and frequently
Before each use
Before each use,
visual check
Before each use
Before each use
Before each use
Before each use
Before each use
Before each use
After each use
Every 5 hours*
Every 5 hours*
Yearly
Yearly