Operation; Operation - Switching On / Off; Adjusting The Magnification - Optelec ClearView+ Manuel D'utilisation

Optelec

4. Operation

When using the ClearView
support at the front of the table for easier access to the
control buttons, and for steady table movement.
If you are using the ClearView
Pack, please refer to the paragraph "Feature Pack – Zero
Button" in chapter 5.
Operation – Switching ON / OFF
To power both the system and monitor, press the ON /
OFF button
magnification button on the reading table. The ClearView
will start up in the same viewing mode as when it was
powered off.
It takes about 10 seconds for the camera unit to initialize
before it displays an image. Within about 1 minute, the
+ system's light source will achieve full brightness,
ClearView
providing optimal image quality.
Please note that a non-ClearView
switched on and off separately.

Adjusting the magnification

Locate the zoom button in the centre of the table,
and turn it clockwise to increase the magnification,
and counter-clockwise to decrease it.
English
+
, place your hands on the wrist
that is located
+
with the Zero Button Feature
right
+
ClearView
above the
monitor must be
+
+
12