Assembly - RIDGID WD45500 Mode D'emploi

INTRODUCTION
UNPACKING
This Product Requires Assembly.
Check all parts from carton against the Carton Contents
List.
If any parts are damaged or missing, contact
1-800-4-RIDGID (US and Canada) or by email at
info@ridgidvacs.com.
CARTON CONTENTS LIST (Fig. 1)
Key Description
A* PRO PACK Powerhead Assembly ............................ 1
B* Dust Drum Assembly ............................................... 1
C* Qwik Lock™ Filter ..................................................... 1
D Extension Wand Clip (Left) ...................................... 1
E Extension Wand Clip (Right) .................................... 1
F Extension Wand ....................................................... 2
G Crevice Tool .............................................................. 1
H Dusting Brush . ......................................................... 1
I Utility Nozzle ............................................................. 1
J Expandable Hose ..................................................... 1
K Owner's Manual. ....................................................... 1
* These parts come preassembled.
C*
D
L
E
R
SP6734-4 4.5 gallon ESF.indb 5 SP6734-4 4.5 gallon ESF.indb 5
Qty
Fig. 1
A*
B*
G
H
I
J
F
K
5

ASSEMBLY

EXTENSION WAND CLIPS INSTALLATION
(Fig. 2)
NOTE: The Extension Wand Clips (D/E) are marked "L"
and "R" and should be installed on the back of the PRO
PACK unit.
NOTE: While viewing the unit from behind, the Clip
marked "L" goes on the Left Side and the Clip marked
"R" goes on the Right Side.
1. Hook the Tab on the bottom of the Extension Wand
Clip (D/E) into the depression in the bottom of the
Dust Drum (B).
2. Rotate the Clip (D/E) upwards until the Extension
Wand Clip snaps into the slots in the Dust
Drum (B).
(B)
(D)
L
Fig. 2
TOP WAND CLIP
ROTATE
WAND CLIP
BOTTOM WAND TAB
(E)
R
(B)
3/4/21 8:43 AM 3/4/21 8:43 AM