Casterassembly; Carry Handle Assembly; Power Head Assembly - RIDGID WD64250 Manuel Du Propriétaire

Caster Assembly
1. Turn the dust drum upside down on
the floor.
2. Insert the caster feet into the bottom of
drum, as shown (4 places).
3. Push on the caster foot until the foot is
flush with bottom of the dust drum.
4. Insert the caster stem into the socket
of the caster foot, as shown (4 places).
5. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will hear the ball snap
into the socket and the caster will
swivel easily when positioning is
correct.
6. Turn the drum upright.

Carry handle Assembly

1. Place the carry handle on the Wet/Dry
Vac power head assembly.
2. Tighten both screws to assemble the
carry handle on the power head
assembly.
Caster
Caster
Stem
Caster
Socket
Drum
5
Screw (2)
Carry
Handle
Power Head
Assembly