Vacuum Assembly; Installing Casters - RIDGID 1250RV0 Mode D'emploi

SP6961 1250RV0 A.qxp_SP6961 6/8/15 9:20 AM Page 5
Unpacking and Checking Carton
Contents (Continued)
Bag of Loose Parts -
Containing the Following:
Key Description
L 2" Casters.....................................4
M Screws, Type AB #10 x 3/4..........4

Vacuum Assembly

Installing Casters

1. Remove lid from the drum/caddy by
unlatching the two latches at the top of
the Vac.
2. Turn drum upside down to expose the
bottom of the drum/caddy for caster
assembly.
3. Insert the caster stem into the socket
of the power base as shown.
4. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will be able to hear the
ball snap into the socket and the
caster will swivel easily when
positioning is correct.
5. Repeat steps 3 and 4 for the three
remaining casters.
6. Rotate drum/caddy upright and
reinstall the lid.
Qty
Lid Latch Hook
Latch (2)
Drum
5
L
B
M
Lid
ROTATE
LATCHES
DOWNWARD
TO UNLOCK
Caster (4)
Caster Stem
Caster Ball
Socket