Caster/Caster Foot Assembly; Filter Removal & Installation - RIDGID WD06700 Manuel Du Propriétaire

Caster/Caster Foot Assembly

1. Turn the dust drum upside down on the
floor.
2. Insert the caster feet into the bottom of
drum, as shown (4 places).
3. Push on the caster foot until the foot is
flush with bottom of the dust drum.
4. Insert the caster stem into the socket
of the caster foot, as shown
(4 places).
5. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will hear the ball snap
into the socket and the caster will
swivel easily when positioning is
correct.
6. Turn the drum upright.
Filter Removal and Installation
To install a new filter you must first
determine which filter attachment system
is used on your vac.
The filter cage has a stud on the end with
either screw threads to receive a filter
nut, or the Qwik Lock™ ball end which
will allow the filter to snap into place
without a filter nut or other attachment
hardware.
The stud type will determine which of the
following sets of instructions should be
used.
!
WARNING: Do not operate
without filter cage and float, as they
prevent liquid from entering the
impeller and damaging the motor.
IMPORTANT: To avoid damage to the
blower wheel, always reinstall the filter
before using the vac for dry material
pick-up.
Caster
Foot
Dust
Drum
Hole
Filter
Lid
Filter
Lid
5
Caster
Caster Stem
Caster Ball
Pin
Threaded
Stud
— OR —
Qwik
Lock™
Stud