Vac Assembly; Removal Of Power Head Assembly; Caster Assembly; Power Head Assembly - RIDGID DV05000 Mode D'emploi

SP6957-2 ASH RIDGID_SP6957 5/13/16 11:58 AM Page 7

Vac Assembly

Removal of Power Head Assembly

WARNING: For your own safety,
never connect plug to power source
outlet until all assembly steps are
complete and you have read and
understood the safety and operation
instructions. Do not operate Vac
with any parts damaged or missing.
1. Grasp the drum latches on both the
right and left side of the Vac.
2. Slowly pull the bottom of the latches
up and away from the drum.
3. The top of the latches will then be free
of the power head.
4. Lift the power head from the drum and
place it on a dry surface.

Caster Assembly

1. After removal of the power head from
drum. Turn the dust drum upside
down.
2. Insert the caster stem into the socket
of the caddy, as shown (4 places).
3. Push on the caster until the caster
stem is inserted all the way into the
socket.
4. Turn the drum upright.
Latches
SNAP
DOWN
LATCH

Power Head Assembly

Lip
ROTATE
LATCH
UP
Caster
Caster
Stem
Socket
Drum
7