Maintenance; Hepa Filter; Filter Removal And Installation - RIDGID DV05000 Mode D'emploi

SP6957-2 ASH RIDGID_SP6957 5/13/16 11:58 AM Page 12

Maintenance

HEPA Filter

WARNING:
injury from accidental starting,
unplug power cord before changing
or cleaning the Filter.
Your HEPA Filter should be cleaned often
to maintain peak Vac performance.
IMPORTANT: It is very important that the
screen filter is installed prior to use.
NOTE: The HEPA Filter is made of high
quality material designed to stop dust and
smaller particles. Handle the HEPA Filter
carefully when removing to clean or
installing a new HEPA Filter. Creases in
the HEPA Filter pleats may occur from
installation but creases will not affect the
performance of the HEPA Filter.

Filter Removal and Installation

Filter Removal:
1. Rotate the filter screen/HEPA Filter
counter-clockwise.
2. Remove the HEPA Filter from the filter
screen.
NOTE: The filter screen should be
cleaned with a brush.
3. Check the motor inlet filter, clean or
replace, if necessary.
Raised Lip
HEPA Filter
To reduce the risk of
Filter
Screen
Filter Installation:
1. Replace motor inlet filter.
2. Replace the HEPA Filter into the filter
screen.
NOTE: Be sure to orient the HEPA Filter
and the filter screen in the correct
position, as shown. The filter screen has
a raised lip on the inside of the screen to
hold it in place.
3. Rotate the filter screen/HEPA Filter
clockwise onto the power head metal
cover.
12
HEPA
Filter
Filter
Screen
Motor
Inlet
Filter
Metal
Cover
Power
Head
Assembly