Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SP6957-2 ASH RIDGID_SP6957 5/13/16 11:58 AM Page 13
Maintenance (continued)
Cleaning A Dry Cartridge Filter
NOTE: For best cleaning results due to
accumulated dust, clean the filter in an
open area. Cleaning SHOULD be done
outdoors and not in the living quarters.
1. Light cleaning of some dry debris from
the Filter can be accomplished without
removing the Filter from the Vac.
Simply slap your hand on top of the
handle while the Vac is turned off.
2. Remove Filter from Vac. Gently tap the
Filter against the inside wall of your
drum, or against the floor, and the
debris will loosen and fall.
Cleaning and Disinfecting the
Ash Vac
To keep your Vac looking its best, clean
the outside with a cloth dampened with
warm water and mild soap.
To clean the drum:
1. Dump debris out.
2. Wash drum thoroughly with warm
water and mild soap.
3. Wipe out with dry cloth.
Cord Maintenance & Storage
When vacuuming is complete, unplug the
cord and wrap it around the power head
handle. If the power cord is damaged,
it must be replaced by the manufacturer or
their service agent or by similarly qualified
personnel to reduce the risk of accident.
Accessories can be stored on the rear
power head or on the caddy base.
Caddy Base
Accessories
- or -
Ash Vac Storage
Before storing your Vac, the drum should
be emptied and cleaned. Wrap the hose
around the top of the cooled power head
assembly, positioning the hose under the
handle, as shown. Accessories should be
kept in the same area as the Vac so they
can be readily available. The Vac should
be stored indoors.
Hose
Hose Wrap
Area
Casters
If your casters are noisy, you may put a
drop of oil on the roller shaft to make
them quieter.
WARNING: To assure product
SAFETY and RELIABILITY, any other
maintenance, repairs and adjustments
should be performed by Authorized
Service Centers, always using RIDGID
replacement parts.
13
Power
Head
Assembly
Cord
Storage
Accessory
Storage
Publicité
Chapitres
Table des Matières
