Wet/Dry Vac Assembly - RIDGID RV24000 Manuel Du Propriétaire

Wet/Dry Vac Assembly

1. Position the Powerhead Assembly on
the Drum/Caddy Assembly, as shown
(assembled earlier).
2. Rotate both Latches down and press
until you hear them snap over the
Flanges on the Drum.
Drum
Latch
Powerhead
Assembly
Latch
Drum
SP6729-5 RIDGID ESF 111418.indb 11
Insert Hose
Insert the Push Button end of the
Professional Locking Hose into the Vac
Inlet. The Professional Locking Hose
should snap into place.
To remove the Professional Locking Hose
from the Vac, press the Hose Assembly
Release Button and pull the Professional
Locking Hose out of the Vac Inlet,
as shown.
Drum
Latch
Press the Curved Metal Extension Wand
into the Coupling Ring of the Professional
Locking Hose End.
Drum
Join the two Metal Extension Wands,
Flange
aligning the Button and Hole so they
snap together.
Attach the Accessories, aligning the
Button and Hole so they snap together.
Metal
Extension
Wand
(Curved)
Accessory
11
Coupling
Ring
Press Release
and Button
Pull
Wet/Dry Vac &
Hose Assembly
Metal Extension
Wand (Straight)
Metal Wand
Button
Accessory
Hole
12/3/18 11:18 PM