RIDGID RV24000 Manuel Du Propriétaire page 9

Drum/Caddy Assembly (cont.)
8. Insert the Caster Stem into the
Socket of the Caster Foot, as shown.
(Front casters only).
9. Push on the Caster until the Ball on
the Caster Stem is inserted all the
way into the Socket. You will be able
to hear the Ball snap into the Socket
and the Caster will swivel easily when
positioning is correct.
10. Install 4 Screws (supplied) into
matching holes on both right and left
side of Caddy, securing the Caddies
to the bottom of the Drum. Tighten
Screws until just snug. Do not over
tighten the Screws, as this may
deform the Caddies.
Installing Metal Handle
Press and hold Release Buttons while
installing Metal Handle into Handle
Receptacles on the Drum
(See illustration).
NOTE: An audible snap of Release
Buttons indicates successful engagement
of Metal Handle.
Removing Metal Handle
Press and hold Release Buttons, as
shown. While firmly pushing in Release
Buttons, pull the Metal Handle upwards
to remove (see illustration).
SP6729-5 RIDGID ESF 111418.indb 9
Caster (2)
Socket
9
Caster Stem
Caster Ball
Screws (4)
12/3/18 11:18 PM