Setting The High-Pass Filter (Hpf) - Sony XAV-7W Mode D'emploi

MENU

Setting the high-pass filter (HPF)

This setting lets you control the frequency response to fit
the characteristics of installed speakers. By choosing the
appropriate high-pass filter cutoff frequency, you can
ensure that the speakers produce crisp mid/high-range
sound. For example, if the 78 Hz setting is selected, only
signal components above 78 Hz are sent to the speakers.
B/b
V/v
Selecting the speaker output cutoff
frequency
Proceed the following steps with the card remote
commander while the monitor is open.
1
Select the source (CD, MD, radio, etc.).
2
Press MENU.
3
Press V or v to select "HPF".
H P F
4
Press B or b to select the cutoff frequency.
Each press of the button cycles through the following
settings:
off (default setting) y 78 Hz y 125 Hz
5
Press MENU.
The regular display appears again.
Cut-off frequency
off
Frequency (Hz)
7 8 H z
39