SATA jet X 5500 Mode D'emploi page 119

Operating Manual SATAjet X 5500 RP/HVLP (DIGITAL)
9.3. Replace air pistons, piston springs and mi-
crometers
• Disconnect spray gun from the compressed air circuit!
This must be exchanged if air is leaking from the air nozzle or the air
micrometer while the trigger is not pulled. After disassembly, grease air
micrometer shell with SATA gun lubricant (item no. 48173), insert with
air piston and tighten locking screw using original SATA combination tool
with max. 1 Nm. [9-1]. After installation, set material throughput according
to chapter 7.2.
• Check if locking screw has been firmly tightened! Air micrometer could
shoot out from the spray gun uncontrolled!
9.4. Repaling the sealing (air side)
• Disconnect spray gun from the compressed air circuit!
Steps: [8-1], [8-2], [9-1], [9-2], [9-3], [9-4] and [9-5]
The self-adjusting seal [9-5] must be replaced if air starts leaking below
the trigger guard.
1. After disassembly, check air piston rod [9-4]; clean if necessary; re-
place in case of damage (e.g. scratches or bending), lubricate with
SATA high-performance grease (item no. 48173) and assemble,
keep an eye on installation height!
2. Also grease air micrometer shell, insert with air piston and tighten locking
screw using original SATA combination tool with max. 1 Nm.
After installation, please adjust material flow according to chapter 7.2.
Steps: [9-1], [9-2] and [9-3]
Warning!
Warning!
Warning!
EN
119