Seko WAREDOSE 35 Manuel D'installation page 5

EN
WAREDOSE 35
1.4 WARNINGS

Check pressure at the rinse injection point in respect of the max-recommended pressure for the rinse
pump.

Check suction tubes are inserted in the correct product tanks (supply containers).

All electrical connections to the WAREDOSE 35 should first be verified with a meter. Application of
incorrect voltage will permanently damage the unit and is not covered under warranty. Avoid wiring to any
power source that has large fluctuations in voltage and/or is prone to surges. Refer to the wiring diagram
in this manual for all power and signal connections.

Check the voltage of the main power source and make sure that it matches the available input voltage
(100-240 Vac) of the transformer inside the WAREDOSE 35.

CAUTION: The WAREDOSE 35 has high voltage connected to the transformer. Always disconnect
power when servicing the unit.

CAUTION: During installation and electrical connections remove all power from the warewasher.

Non-compliance to any of the dispositions hereby contained may cause damage to persons or things
or the incorrect functioning and damage to parts of the equipment.
0000138112 rev. 1.0 3