Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling; Carbon Brushes - EINHELL BT-SS 405 E Mode D'emploi D'origine

Anleitung_BT_SS_405_SPK1:_
GB
6.5 Adapter for jigsaw blades (Fig. 8/9)
Remove the saw blade as described in 5.3.2.
Now insert the fretsaw blade (a) in the adapter.
First remove the table insert (18).
Then hook both adapters (22) on the two saw
blade holders (8/13).
Insert the saw blade as described in 5.3.2.
7. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
7.2 Bearings
Lubricate the bearings of the guide rollers
periodically with high-grade machine grease, but at
least after every 25-30 hours in operation.

7.3 Carbon brushes

In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
7.4 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.5 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
12
06.12.2010 7:27 Uhr Seite 12

8. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.