Operation Of Control Panel - Arktic 232040 Mode D'emploi

Symbol Name
Up/Switch
Down/
Defrosting
Set/Mute
Aux
Clock (RTC)
Alarm
Cooling Fan
Defrosting
Compresor

7.6. OPERATION OF CONTROL PANEL

7.6.1. CHANGING THE SET VALUE
• In order to display the set value, press and imme-
diately release the [SET/MUTE] button.
• Press and hold the [SET/MUTE] button for at least
1 seconds to change the set value. The current set
value will be displayed.
Type Mode
Press and hold for
min. 3 seconds
Button
Press and release
Press and hold for
min. 3 seconds
Button
Press and release
Press and release
Press and hold for
Button min. 1 seconds
Press and hold for
min. 3 seconds
Light Illuminated
Light Illuminated
Light Illuminated
Illuminated
Light
Blinks
Illuminated
Light
Blinks
Illuminated
Light
Blinks
Meaning
Switch ON/OFF
Scrolling functions; increasing the value of the
selected parameter (In the programming mode)
Manual defrosting will start
Scrolling functions; decreasing the value of the
selected parameter (In the programming mode)
Mutes the audible alarm
Displays/sets the set point
Accesses the parameter setting menu
The additional output active (service mode only)
RTC available, enabled (tEN=1) and at least one
time band has been set (service mode only).
Alarm in progress
Fan activated
The start of fan is delayed due to
external shut-off; other procedure is in progress
Defrosting in progress
The start of defrosting is delayed due to external
shut-off; other procedure is in progress
Compressor on
The start of Compresor is delayed by protective
procedure
• To change the set value, press the [UP/SWITCH]
or [DOWN/DEFROSTING] arrows. To store the
new set value, press the [SET/MUTE] button again
or wait 15 seconds.
EN
11