Before The First Use; Transport - Arktic 232040 Mode D'emploi

6. BEFORE THE FIRST USE

6.1. TRANSPORT

• Special package box is required for the delivery of
the equipment. Keep the equipment level during
transportation and handling.
• Please carefully check the package box after re-
ceiving the product to ensure that the equipment
is not damaged during transportation.
• Check for the completeness of the equipment. In
case of incomplete delivery and damages. Please
contact supplier (See == > Warranty).
• When removing the package box, carefully move
away the wood plate in case of scratch the equip-
ment.
• In case that the equipment tilts during the trans-
portation and handling, the lubricant in the com-
pressor may flow into the cooling loop. Therefore,
in order to ensure the lubricant flows back to the
compressor, it is necessary to keep the equipment
level for 24 hours before plug in the equipment
and starts to work.
• Do not throw away the package randomly. Please
dispose as per relevant local rules and regula-
tions.
• Clean all components as described (See == >
Cleaning and Maintenance).
• Place all the shelves inside the appliance.
NOTE: Due to manufacturing residues, the appli-
ance may emit a slight odor in the first few cycles.
This is normal and does not indicate any defect or
6.2. PACKAGING
Upon receipt of the appliance, check the packaging
for any transport damage.
Carefully remove the external cardboard, loosen the
bolts fixing the appliance to the pallet (if present -
they secure the appliance from movement during
transport), put the appliance aside and remove the
protection film from the outer housing.
6.3. LEVELLING
To ensure correct functioning it is important to level
the appliance. Correct levelling allows for reduction
of vibration generated by the unit in operation.
The appliance is supplied with adjustable feet.
Thoroughly check the levelling with the use of a
spirit level.
hazard. Make sure the appliance is well ventilated.
• Turn on the lighting switch, check the light is nor-
mal.
• The digital temperature controller is delivered
with default parameters. Do not alter the param-
eters casually except for special need.
• When running for the first time, it should run
without load for 2 hours to ensure the refriger-
ation system is working normally. Only when the
temperature within the appliance is reduced with-
in the indicated scope can the food be put into the
appliance.
• Don't put too much food in the appliance to pre-
vent instantaneous high load. The food shall not
block the air outlet and air inlet. Nor shall it be
close to side glass. Otherwise it will lead to con-
densation.
• To keep the taste of the food, please have the
equipment running 24 hours a day.
• During the frosting process, the temperature of
the appliance may rise slightly. When the frosting
end, it will return to normal.
ATTENTION: During transport, avoid skew the unit
from the vertical by an angle greater than 30 °, If
necessary, wait approximately 3-4 hours before
running, until the oil flows to the unit. Otherwise,
the condensing unit may be damaged.
By recycling of packaging materials such as plas-
tics, steel, cardboard and wood, we significantly
contribute to saving raw materials and waste re-
duction.
Comply with local regulations regarding the meth-
od and place of disposal of the appliance packaging
materials.
EN
7