Maintenance - Thermador MASTERPIECE Serie Mode D'emploi

Maintenance

Replacing an Oven Light
CAUTION
9
WHEN REPLACING AN OVEN LIGHT:
Make sure the appliance and lights are cool and
▯
power to the appliance has been turned off
before replacing the light bulb(s). Failure to do so
could result in electrical shock or burns.
The lenses must be in place when using the
▯
appliance.
The lenses serve to protect the light bulb from
▯
breaking.
The lenses are made of glass. Handle carefully to
▯
avoid breaking. Broken glass could cause an
injury.
Light socket is live when door is open.
▯
Use only 120 volt, 25 watt halogen light bulbs, G9 base.
These bulbs can be purchased through retail stores.
Use a clean, dry cloth to handle halogen light bulbs. This
will increase the life of the bulb.
Hint: Some users may find it helpful to remove the oven
door to provide easier access and visibility. See the
following section: "Removing the oven door".
To replace the halogen bulb on the oven ceiling:
Turn off power to the oven at the main power supply
1.
(fuse or breaker box).
Remove the oven racks if necessary to provide access
2.
to the bulb housing.
3. Remove the glass cover by unscrewing it.
26
The halogen bulb is visible in the light fixture.
4.
5. Remove the halogen bulb by pulling it out of the 2 pin
socket. Pull straight down and out.
6. Replace with a new halogen bulb. Grasp the new bulb
with a clean, dry cloth. Press the 2 pins on the bulb
into the socket holes until the bulb is firmly seated.
Screw the glass cover back on.
7.
8. Turn power back on at the main power supply (fuse or
breaker box).
To replace the halogen bulb on the oven sidewall:
Tools required
è  PP
Narrow flat blade screw-
driver (blade tip width 1/
5" (5 mm) or less to fit in
slot).
Flashlight (to see socket
holes to plug in bulb
prongs).