Thermador MASTERPIECE Serie Mode D'emploi page 28

To access the toggle locks, remove the locking plate
4.
using a T20 star head driver.
After removing the screw, (A) lift the locking plate up
5.
and then pivot it out to remove. Repeat for the other
hinge. Retain both locking plates and screws for
reinstallation.
6. Flip the locking levers towards the door as far as they
will go. Hint: (B) It may be helptul to use the tip of a
screwdriver to pull out the locking levers. (C) Make
sure both locking levers are in the locked position
pushed all the way towards the door.
28
With the toggles in place as shown, carefully close the
7.
oven door until the front side of the door is about
5½ inches (140 mm) from the control panel.
Grasp the door firmly using both hands. The door
8.
weighs over 30 pounds.
CAUTION
9
To avoid damage do not allow the door to strike
the control panel during door removal or
replacement.
9. Lift the door up and pull out at an upward angle as
shown in the following illustration. The notch in the
hinge foot will disengage from the oven door frame.
With both door hinge feet disengaged, lift the door off
the unit.
10. Carefully move the door to a safe place to protect it
from damage until you are ready to reinstall it.
Replacing the Oven Door
To replace the oven door:
Hold the door firmly in both hands at a 30° angle to
1.
the front of the unit.
2. Guide the door hinges into the hinge slots on the unit
housing.
Slide the door in until the slots on the hinges engage
3.
the oven housing. Hint: it may be necessary to rock
the door slightly to seat it correctly.
Lower the door into the fully open 90° position. If the
4.
door will not lower all the way to the 90° position, the
hinges are not correctly seated. The door should be
straight, not crooked.
Push the locking toggles back into the unlocked
5.
position, toward the oven cavity.
Reinstall the locking plates and screws (see door
6.
removal process above).
Close the door gently. It should close all the way.
7.
Gently open and close the door several times to be
sure it is correctly installed and securely in place.