Nussbaum WA 780 Manuel D'instructions page 99

- Tilt the left-hand front or
rear measuring sensor (depending on the
selected procedure) until the infrared
measuring ray is able to "pass" beneath
the spoiler;
- Press the F3 key
measuring sensor inclination angle
- Tilt the front or rear right-
hand measuring sensor (depending on the
selected procedure) as described above;
obtaining this condition is assisted by the
movement of the cursor on the graduated
scale shown on the screen, and signalled
by appearance of the "STOP" icon.
- "Level" the two measuring
sensors
Press F3 to display the "Rear axle
measurement and adjustment window".
If the infrared measuring beam is still ob-
structed after the second measuring sensor
has been tilted to the level indicated, the
user must repeat the procedure, lowering
the first sensor further and readjusting the
position of the second sensor. The pro-
gramme guides the operator through the
procedure with the same icons described
above.
User Manual WA 780 - Cura S 780
Note:
If the front and rear spoilers are fitted,
independently from the spoiler procedure
selected, at the end of the procedure on the
axle selected, the programme will indicate
that the spoilers are fitted and will ask you
if you wish to perform the procedure on
the other axle.
It is possible to choose whether or not to
perform the second spoiler procedure,
which, in this way, will allow set back
to save the
measurement on both axles.
During execution of the Spoiler pro-
gramme, the following keys are active:
F1
F2
F3
F11
These are the menu options:
• End of work (goes back to the starting
screen)
• Help (recalls the Help screen relative to
the current screen)
displays the on-line "Help"
function
goes back to the previous
screen
(or Enter) goes to the next
screen
displays the menu with the
relative functions.
GB
99