Nussbaum WA 780 Manuel D'instructions page 108

Note: Find an example of a screen with all
the settings on fig. 37.
"Save Data" manual execution
To perform "Save Data" manually, proceed
as follows:
1. From the starting screen (Logo screen),
open the drop-down menu, pressing
"F11".
2. Select "Setup" with the ↑ or ↓ arrows.
3. Press "Enter" ↵ to confirm.
4. Wait until the aligner general set-up
screen is displayed.
5. Open the drop-down menu, pressing
"F11".
6. Select "Salvataggio Dati" ("Store Data")
with the ↑ or ↓ arrows.
7. Press "Enter" ↵ to confirm.
The screen on figure 44 will be dis-
played.
N.B.: To move through the different objects
(boxes) present on the screen, use the tab
key.
8. Use the ↑ or ↓ arrows to select the disc
where you wish to "Store the data" in
field "B".
9. Use the↑ or ↓ arrows to select the folder
where you wish to "Store the data" in
field "C".
10. Press "Enter" ↵ to confirm.
The data filing path is displayed in full
in the field "A".
N.B.: the instructions contained from point
11 to 13 inclusive refer to the settings related
108
to the automatic Backup (see note)
11. In the field "D", it is possible to select
automatic filing (Data Saving) using the
space bar.
12. In the field "E", indicate how often you
wish to perform "Data Saving" using the
numeric keypad.
13. In the field "F", it is possible to select
whether or not to ask if you wish to
perform automatic filing (Data Saving)
pressing the space bar.
14. In the field "G", it is possible to select
whether the information (Data Saving)
37
is filed in compressed format (zip) or
as a simple copy of the files, pressing
the space bar.
15. After setting your own choices, press
"F11".
16. Select "Esegui archiviazione dati" ("Ar-
chive data") with the ↑ or ↓ arrows.
17. Press "Enter" ↵ to confirm.
18. Press "F3" to confirm.
19. Press "F2", to exit the "Save Data" set-
tings screen and go back to the aligner
general set-up screen.
20. Press "F2" to go back to the starting
screen (logo screen).
Note: The path selected to perform the
manual filing is valid exclusively for this filing,
the last path saved remains in the memory,
performing the procedure described in the
"Save Data" procedure setting up" section. If
you wish to save these settings permanently,
before step 19, follow the instructions con-
tained from point 11 to 13 inclusive and the
carry out the following operations:
d) Open the drop-down menu pressing
"F11".
e) S e l e c t
d'archiviazione" ("Save archiving set-
tings") with the ↑ or ↓ arrows.
f) Press "Enter" ↵ to confirm.
"Save Data" automatic execution
At the end of the period that was set up, the
programme automatically performs the "Save
Data" procedure.
User Manual WA 780 - Cura S 780
" S a l v a i m p o s t a z i o n i