Nussbaum WA 780 Manuel D'instructions page 67

electrical connector panel (H, fig. 2) and
fasten them into the 2 charging cable re-
tainer brackets at the back of the cabinet.
• Unpack the keyboard, place it on the
shelf provided in the moulded casing
and insert the data cable through the ca-
ble guide in the shelf.
• Unpack the computer (keep the pack-
ing material so that the machine can be
safely shipped at a later date if neces-
sary) and lay it inside the wheeled cabi-
net on the specific compartment.
• Unpack the monitor (keep the packing
material so that the machine can be safe-
ly shipped at a later date if necessary)
and lay it on the top of the console.
WARNING
The LCD monitor should always be se-
cured, to prevent possible damage
caused by accidental collision with
equipment.
• Pass the monitor cables through the ca-
ble guide on the rear side of the cabinet
to access the computer compartment.
• Connect the monitor power supply ca-
ble to one of the Shuko sockets.
• Connect the monitor signal cable to the
PC, as shown (B, fig. 2).
• Tie the power supply cables and moni-
tor signal cables together outside using
two clamps.
• Connect the cables below to the com-
puter as indicated in fig. 2: power supply,
keypad and printer.
• Assemble the 4 measuring sensor sup-
ports on the sides of the cabinet, using
the corresponding holes and 4 Allen
screws provided.
• Once all connections are made, refit the
rear cover panel of the cabinet.
NOTE
Arrange the various connection cables ti-
dily, laying them along logical routes and
avoiding unnecessary extra length or tan-
User Manual WA 780 - Cura S 780
gles (see fig. 3); if necessary, fasten them
together with clamps, at several points.
CAUTION
For additional information about the
technical characteristics,
maintenance and any other data about
the monitor or the printer, read the rela-
tive operator's manuals supplied with
machine documentation.
warnings,
3
GB
4
5
67