Installation; Installing The Electrical Connector (Panel Card); Installing The Hard Lock Device - Nussbaum WA 780 Manuel D'instructions

INSTALLATION

• Unpack the equipment, placing the pack-
aging in the position indicated above.
• Remove all the accessories on the pal-
let and inside the machine and put them
aside.
• Move the aligner into the required po-
sition (see paragraph "Installation clear-
ances").
• Unpack the accessories.
Installing the electrical connector (panel
card)
• Install the electrical connector panel at
the top of the cabinet (H, fig. 2). Connect
the electrical connector panel to one of the
HDD power supply cables leading out of
the back of the PC and to the Hard Lock
device with a USB cable (G, F, fig. 2).
66

Installing the Hard Lock device:

• Insert the tip of a pen (or similar) into
the hole at the side to open the SIM
holder (fig. 4).
• Remove the aligner SIM Card (fig. 5).
from its punched support (keep the sup-
port with the serial number for future ref-
erence) and insert in the SIM holder (fig.
4), with the gold contacts facing upward.
• Push the SIM holder in.
• Fix the Hard Lock device and the 2
charging cable retainer brackets onto the
back of the cabinet, with the relative fas-
tener screws.
• Connect the 2 USB cables to the Hard
Lock device. Connect one to an unused
USB port on the PC; connect the other to
the USB port on the electrical connector
panel card (E, F, fig. 2).
• Connect the 4 measuring sensor charg-
ing cables (with RJ45 connectors) to the
User Manual WA 780 - Cura S 780
2