Cleaning; Fuse Replacement; Disposal; Product - Renkforce DL-PAR101 Notice D'emploi

a) Cleaning
Never use aggressive and abrasive detergents, rubbing alcohol or other chemical solutions,
as these could damage the casing or even impair the functioning of the product.
• Disconnect the product from the power supply before cleaning.
• Do not immerse the product in water.
• The outside of the LED spot should only be cleaned with a soft, dry cloth or brush.
• Leave maintenance or repair work to an expert.
b) Fuse Replacement
If the event that you need to replace the fuse, ensure that you only use fuses of the specified type and rated
current as a replacement (see "Technical data").
Never repair fuses or bridge the fuse holder.
• Unplug the mains plug from the mains socket and disconnect the low-voltage cable from the POWER IN
socket (8) on the device.
• Using a suitable screwdriver, carefully lever the fuse holder containing the defective fuse from the
POWER IN socket.
• Remove the defective fuse and replace it with a new fuse of the specified type.
• Carefully push the fuse holder with the new fuse back into its position on the device's mains connection.
• Only then should you reconnect the device to the mains and put it into operation.

17. Disposal

a) Product
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product according to the relevant statutory regulations.
If a battery is inserted, remove it and dispose of it separately from the product.
54