Setting The Menu Options; Setting The Operating Modes - Renkforce DL-PAR101 Notice D'emploi

c) Setting the menu options
Display Operating mode
e e
Turn off display after inactivity
L on / L oF
Turn on display when a
buttons is pressed
e
Inverts display
L d
Iron / Enable remote control
IroF
Inverting the display orientation
As the LED spot can be placed on a surface or hung from a ceiling, the display orientation can be rotated
180°.
• Press the MODE button (12) until L
the display from reverting to the previous screen.
• Use the SET UP button (11) to select the menu option L
• Select the display orientation using the UP (10) or DOWN (9) buttons. The display is immediately rotated
by 180°. Press the button again to revert to the original orientation.
If you cannot read the values on the display properly, turn the LED spot by 180° to view the
display from the other side.
Setting the display to turn off after a period of inactivity
You can set the LED display to turn off after a period of inactivity. If no buttons are pressed or no control
signals are received from an IR remote control after a certain period, the LED display will switch itself off
automatically. Follow the steps below to program the LED display.
• Press the MODE button (12) until L
• Select the desired option (if necessary) using the DOWN (9) or UP (10) buttons.
Enabling remote control
• For details, please refer to chapter 14. Controlling with the IR remote control.
d) Setting the operating modes
DMX mode
• Press the MODE button (12) until "Axxx" appears. Select a DMX starting address using the UP (10) or
DOWN (9) buttons.
• Press the SET UP button (11) until "Chxx" appears. Select a channel mode using the UP or DOWN buttons.
Refer to chapter 13. Operation, e) Operating with an external DMX controller.
Option
on or oF
(off)
Mirrored
on
oF (off)
e e
on or L oF is displayed. Press a button within 5 seconds to prevent
e
e
oF/on appears. Only the current option is displayed.
Function
Turn off display
Turn on display
Select display orientation
Remote control enabled
Remote control disabled
d.
45