Renkforce DL-PAR101 Notice D'emploi page 52

Button Function
FADE MODE
Fa
Activates the fade effects. Use the +/- buttons to select the desired fade effect (00-09).
Use the SPEED button and the +/- buttons or the number buttons (0-9) to set the effect speed.
SPEED
Sp
Sets the desired effect/strobe speed. To adjust the speed, use the +/- buttons or directly
enter a number via the keypad (0-9).
COLOR MODE
Cl
Activates the mode with preset colours. Use the +/- buttons or the number buttons (0-9) to
select the desired colour setting (Co01-Co32).
Use the SPEED button and the +/- buttons or the number buttons (0-9) to set the strobe
speed.
+ and -
+
These buttons are used to set different values, e.g. the speed setting for effects, strobe, etc.
–
This button has no function.
W/A
R / G / B
R
These buttons activate the manual colour setting mode.
G
Set the brightness of individual colours by pressing the desired colour button (R, G or B) and
adjusting the brightness of this colour with the +/- or the number (0-9) buttons.
B
Use the SPEED button and the +/- buttons or the number buttons (0-9) to set the strobe speed
(FS00-FS15).
These buttons are used to set different values using numbers, e.g. the speed setting for
0
effects.
Set Addr
S_A
Use this button to set the DMX starting address.
Set the DMX starting address with the number keys (0-9).
The +/- cannot be used to set the DMX starting address.
Set Channel Mode
S_C
Use this button to set the DMX operating mode (1Ch-7Ch).
Use the +/- buttons or the number keys (0-9) to set the number of DMX channels.
When a value that is not supported by the device is set with the number buttons, the light will
briefly flash three times.
52