Maintenance; Cleaning; Fuse Replacement - Renkforce 1494841 Notice D'emploi

13. Maintenance

Regularly check the technical safety of the effect light, e.g. for damage to the mains cable or the casing.
Always observe the following safety instructions before cleaning or servicing the effect light:
Live components may be exposed if covers are opened or components are removed.
The device must be disconnected from all power sources before any servicing or repair work is carried out.
Capacitors inside the device may still carry voltage even though they have been disconnected from all
power sources.
Only qualified experts familiar with the hazards involved and the relevant regulations must perform repairs.
a) Cleaning
The outside of the effect light should only be cleaned with a soft, dry cloth or brush.
Never use any aggressive cleaning agents, cleaning alcohol or other chemical solutions, since these may
damage the casing or even impair function.
• Always disconnect the product from the power supply before cleaning it.
• Use a dry, lint-free cloth for cleaning the product.
b) Fuse Replacement
If it becomes necessary to replace a fuse, make sure that only fuses of the prescribed type and nominal current are
used (see "Technical Data").
Never repair fuses or bridge the fuse holder.
• Unplug the mains adapter from the mains socket.
• Use a suitable screwdriver to carefully turn out the fuse holder FUSE (5) with the defective fuse.
• Remove the defective fuse and replace it with a new fuse of the indicated type.
• Carefully screw the fuse holder with the new fuse back into the device FUSE (5).
• After this, you can reconnect the device to the mains and take it into operation.
All manuals and user guides at all-guides.com
43