Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• If the flashlight is turned on, it will turn off as soon as there is insufficient battery power
remaining.
b) Bluetooth connection
The maximum Bluetooth range with no obstructions is 10 m. The range may be shorter
depending on the surroundings and interference factors.
The product can be used to transmit audio and control phone calls from a Bluetooth mobile phone,
or transmit audio from an audio playback device with Bluetooth. These devices are referred to as
"Bluetooth devices" below.
Enable Bluetooth on the device that you wish to pair with the flashlight.
1.
To turn on the pairing mode, hold down the
a low beep followed by a higher beep. The red and blue indicator lights flash alternately.
2.
The product will appear as "AT-201" on your Bluetooth device. Pair your device with the
flashlight. If a password is required, enter "1234".
3.
Once you have paired your device with the flashlight, the blue indicator will flash once every
5 seconds.
Terminating the Bluetooth connection:
• Hold down the
button for 2 seconds until you hear a low beep and the red indicator turns
on briefly.
Re-establishing the Bluetooth connection:
• If Bluetooth is enabled on your device and the product is a known Bluetooth device, hold down
the
button for approx. 3 seconds until you hear a low beep followed by a higher beep.
c) Audio playback
1.
Pair your device with the flashlight.
2.
Play some audio (e.g. music) on your Bluetooth device. The audio will be played back via the
speaker. Refer to "Table 3".
Function
Button
Volume up
Hold down
Volume down
Hold down
Pause/start
Press
repeatedly
d) Phone calls
When using the microphone, keep a sufficient distance from speakers to prevent
feedback.
1.
Pair your device with the flashlight.
2.
Incoming calls will be redirected to the product and you will hear a ringtone. Audio playback
will be automatically stopped. Refer to "Table 4" for information on controlling calls. Speak
into the microphone (7).
Function
Button
Answer call
Press
End call
Press
e) Power bank
The power bank delivers a maximum current of 1.2 A.
1.
If the flashlight is turned on, turn it off first.
2.
Remove the flashlight base.
3.
Hold down the
button (5) for approx. 3 seconds until the green indicator turns on.
4.
Connect a suitable USB cable to the USB port and the other end of the cable to the mobile
device that you wish to charge.
• Turn off the power bank by pressing the
f) Flashlight
The LED in the flashlight cannot be replaced.
Use the
button to control the flashlight. Press the button repeatedly to scroll through the
various functions. Refer to "Table 5".
Flashlight functions:
1x press
Light on;
Green indicator flashes slowly
2x press
Strong brightness level;
Green indicator flashes quickly
3x press
Flashlight flashes
Green indicator flashes slowly and in sync with the flashlight
4x press
Flashlight flashes quickly
Green indicator flashes quickly and in sync with the flashlight
5x press
Light off;
Indicator light turns off
button (2) for approx. 7 seconds until you hear
Function
Button
Next track
Press
*
Previous track
Press
You will hear a beep when the
*
maximum volume is reached.
Function
Button
Decline call
Press
for approx. 3
seconds
button repeatedly until the green indicator turns off.
g) Mounting the flashlight
The flashlight can be secured to a pole using the support included with the product.
1.
Loosen the clamping screw.
2.
Put the support arch over a pole. The rubber insert provides additional support.
3.
Screw the clamping screw in place.
4.
Insert the product into the support. Depending on where you position the flashlight, it may
be a good idea to take additional measures to prevent it from falling out of the support (e.g.
with a rubber band).
Maintenance and cleaning
• Disconnect all connected devices and cable connections before cleaning.
• Do not let any liquids enter the product.
• Do not immerse the product in water.
• Never use aggressive and abrasive detergents, rubbing alcohol or other chemical solutions, as
these could damage the casing or even impair the functioning of the product.
• A dry, soft and clean cloth is sufficient for cleaning. Do not press too hard on the housing as this
can lead to scratch marks. Dust can be easily removed using a soft and clean long-haired brush.
Declaration of Conformity (DOC)
Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau hereby declares that this product
conforms to the 2014/53/EU directive.
Click on the following link to read the full text of the EU declaration of conformity:
www.conrad.com/downloads
Select a language by clicking on a flag symbol and enter the product order number in
the search box. You can then download the EU declaration of conformity in PDF format.
Table 3
Disposal
Electronic devices are recyclable waste and must not be disposed of in the household
waste.
At the end of its service life, dispose of the product according to the relevant statutory
regulations.
You thus fulfil your statutory obligations and contribute to the protection of the
environment.
Technical data
Rechargeable battery...................................................Li-ion 2300 mAh
Operating voltage..........................................................3.7 V
Charging voltage ...........................................................5 V/DC (via USB)
Charging times............................................................... USB interface: approx. 6 hrs
Battery life ...................................................................... Audio playback: approx 10 hrs
Table 4
Bluetooth ........................................................................Version 3.0
Transmission frequency ...............................................2402 – 2480 MHz
Transmission power .....................................................≤3 dBm
Bluetooth range.............................................................max. 10 m
Power bank ....................................................................5 V/DC, 1.2 A
Loudspeaker power ......................................................2 W RMS
Signal-to-noise ratio .....................................................82 dB
Frequency response .....................................................250 Hz – 20 kHz
Flashlight ........................................................................ Power: 1W
Operating and storage conditions .............................-20 to +60 °C, 0 – 85 % RH
Dimensions (Ø x L) ........................................................38 x 156 mm
Weight .............................................................................approx. 132 g
Table 5
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the
technical status at the time of printing.
© Copyright 2016 by Conrad Electronic SE.
USB power adapter: approx. 3 – 5 hrs
Phone calls: approx. 40 – 50 hrs
Flashlight: approx. 4 – 5 hrs
Illuminant: LED
colour temperature: 6000 – 6500 K
Light range: 40 – 50 m
V2_0816_02_JH
Publicité
Table des Matières
