Network Configuration; Connecting To A Power Supply; Using The Device For The First Time - Medion LIFE P85023 Mode D'emploi

8. Network confi guration
Two network configurations are possible for the Internet radio: WLAN mode (wire-
less) or LAN mode (with an Ethernet cable).
• If the Internet connection is to be set up using an Ethernet cable, go to the set-
up wizard and select the connection type WIRED. You can manually change all
settings later in the system settings.
• If you have a wireless 802.11 a/b/g/n network, you can connect the Internet ra-
dio to the Internet via WLAN:
During the initial start-up you will need to select an access point (AP) and possi-
bly enter the network key. The radio will then always tune in to this AP automati-
cally. A message will appear if the device is unable to find the AP.

9. Connecting to a power supply

 Plug the mains cable supplied (model number KSAS0241200150HE) into the DC
IN socket on the device.
 To switch on the power, switch on the radio using the On/Off switch at the back.
10. Using the device for the fi rst time
• When using for the first time, you will first see a selection where you can set the
menu language.
 Select the language that is to be displayed in the menus and then press the OK
dial to confirm.
The setup wizard appears (in the previously selected language):
 Confirm the query "SETUP WIZARD START NOW?" with YES in order
to start the setup wizard.
NOTE!
If you select NO, in the next display you can specify whether the wizard
should start the next time you switch on the device.
64 of140
Setup wizard
Start now?
YES NO