Maintenance/Servicing - Eaton CROUSE-HINDS Série Mode D'emploi

6.3 Closing flood light
Fig 10 ... 11
Remove all foreign bodies from the device.
– Pay attention to the correct fit of the enclosure top part and the seals.
– All seals must be clean and undamaged.
– The flood light may not be damaged.
– Tighten all enclosure combi-screws evenly diagonally (test torque see
technical data).
Mind! Overtightening might impair the pull-relief effect!
7 Taking into operating
Prior to taking the apparatus into operation, the tests specified in the
relevant national regulations will have to be carried out.
Apart from that, the correct functioning and installation of the apparatus
in accordance with these operating instructions and other applicable
regulations will have to be checked (IEC/EN 60079-14).
Please observe the following before closing the flood light:
– All seals must be clean and undamaged.
– The flood light may not be damaged.
Improper installation and operation of the lamp leads to loss of the
guarantee.
8

Maintenance/Servicing

The required maintenance intervals are set according to their
application and should therefore be determined depending on the
conditions of use.
Warning against electric shock.
Before opening the enclosure make sure that the apparatus is
disconnected from the voltage, or take the appropriate protective
measures.
Make sure that there is no explosive ambient atmosphere when
opening the equipment.
The relevant national regulations which apply to the maintenance/
servicing of electrical apparatus in explosive atmospheres, shall be
observed (IEC/EN 60079-17).
8.1 General Maintenance / Inspection
Within the scope of the maintenance / inspection, especially those parts
on which the type of protection depends must be checked for damage, e.g.:
– Protective hoses over the connecting cables.
– Housing and protective glass for any cracks or damages.
– Seals for the flood light and cable glands.
– Cable entries must be free from corrosion!
– Terminals and blanking plugs must be checked for secure fitting.
If during servicing repairs prove to be necessary, section 9 of these
operating instructions will have to be observed.
Explosion protected flood light type: PXLED
9
out by COOPER CROUSE-HINDS or a qualified electrician (Compe-
tent person) in compliance with the applicable national rules
(IEC/EN 60079-19).
CROUSE HINDS-/ EATON may be used.
Should the flameproof enclosure be damaged, only a replacement
will be permitted. In case of doubt, the respective apparatus will
have to be returned to COOPER CROUSE-HINDS / EATON for repair.
Modifications to the device or changes of its design are not permitted.
They shall be used for their intended purpose and in perfect and
clean condition.
10
When the apparatus is disposed of, the respective national regulations on
waste disposal will have to be observed.
In case of disposal you can obtain additional information from your Cooper
Crouse-Hinds / EATON branch.
Subject to modifications or supplement of the product range.
Repairs / Overhaul / Modification
Repairs that affect the explosion protection, may only be carried
For replacement and repair only original parts from COOPER
Disposal/Recycling
GB
13