Use; Switching The Machine On/Off - Victoria Arduino VA358 White Eagle Manuel D'instructions

Machine à café express professionnelle
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.

USE

Before starting to use the appliance, the operator
must be sure to have read and understood the
safety prescriptions contained in this booklet.
NOTE: At the start of the daily activity and
anyway in case there are pauses longer
than 8 hours, one must proceed to
make happen the 100% change of the
water contained in the circuits using the
specific nozzles.
4.1
SWITCHING THE
MACHINE ON/OFF
SWITCH ON: plug the machine into the
power socket and press the
switch "A" so it is in position "I";
the machine will switch on.
A
WARNING
If the self-diagnostics report anomalies or
failures, the operator MUST NOT intervene.
Please contact the Assistance Centre.
• The display, which is not illuminated, will
read:
OFF
48
NOTE: The machine is not operational, since
the main switch only powers the elec-
tronic card.
WARNING
For electronic card maintenance, turn the
machine off by means of the external main
switch or disconnect the plug.
MANUAL SWITCHING ON/OFF:
Automatic On/Off NOT PROGRAMMED:
NOTE: make sure that the general switch is
always on the position "I".
SWITCH ON: press the ON/OFF button
for about 2 seconds until the
light
The control unit will start up an
auto diagnosis cycle to check
the functions, all the selection
Fig. 12
keys will light up.
After the diagnostics stage, the
"Home Page" will open on the
screen":
1.21 bar
NOTE: on completion of the check up all the
selection keys are activated.
In case the auto diagnosis indicates error or
malfunction, call an assistance centre; the
operator MUST NOT intervene.
SWITCHING OFF: press the ON/OFF button
switches on.
Automatic On/Off PROGRAMMED:
NOTE: make sure that the general switch is
The machine will SWITCH OFF at the first
time set for stopping the coffee maker (see
the PROGRAMMING chapter and the
ENERGY SAVING section).
Fri/09/09 14:45
The control unit will perform an auto diagnosis
of all functions and all of the selection keys will
light up.
After the diagnostics stage, the "Home Page"
will open on the screen:
Menu
WARNING
for about 2 seconds, until
the light switches off
The machine will switch off and
the display will read:
OFF
always on the position "I".
.

Publicité

Table des Matières
loading

Table des Matières