Cleaning; Switching Off; Cleaning The Outside Of The Machine; Cleaning The Stainless Coffee-Holders - Victoria Arduino VA358 White Eagle Manuel D'instructions

6.

CLEANING

6.1

SWITCHING OFF

To switch the machine off press the main switch
and set the machine to the "O" energy position.
6.2 CLEANING THE
OUTSIDE
OF THE MACHINE
The machine must be set to "O" power (switch
off and disconnector open) before any cleaning
operations are performed.
WARNING
Do not use solvents, chlorine-based prod-
ucts or abrasives.
WARNING
It is not possible to clean the machine using
water jets or standing it in water.
Cleaning the work area: remove the worktop,
lifting it up from the front and sliding it out.
Remove the water collection dish underneath and
clean everything with hot water and cleansers.
Cleaning the bottom: To clean all the chromi-
um-plated areas, use a soft, damp cloth.
60
6.3 CLEANING THE
STAINLESS
COFFEE-HOLDERS
The stainless coffee-holders are situated under
the delivery units.
NOTE: To clean proceed as follows:
• Turn the screw placed in the centre of the
coffee-holder.
• Slide the coffee-holder out and check that its
holes are not obstructed but clean.
• If obstructed, clean as described.
We recommend cleaning the coffee-holder
once a week.
6.4 CLEANING THE
UNIT WITH
THE AID OF THE
BLIND FILTER
The machine is pre-set for cleaning the delivery
unit with a specific washing powder.
The machine will initiate washing cycle which
consists in the circulation of hot water followed
by regular breaks.
We recommend carrying out a washing cycle at
least once a day with special cleansers.
RISK OF INTOXICATION
Once the filter-holder has been removed,
repeat delivery operations a few times to
eliminate any cleanser residues.
To carry out the washing procedure, proceed as
follows:
• Substitute the filter with the delivery unit
blind filter.
• Fill it with two spoonfuls of special cleanser
powder and insert it into the unit filter-holder.
Press the cleaning button and select the group
to be washed.
The machine will start making a series of washes,
after which they will be asked to do the rinsing.
Fig. 22
• Remove the filter holder and rinse under
running water to remove any soap residue.
• Put back the filter holder and press the flash-
ing button in the group to start rinsing.
• At the end remove the filter holder and make
some operations.
• Press one of the coffee keys and halt it after
10 seconds.
• Repeat the procedure several times.
• Remove the filter-holder and carry our a few
deliveries.
6.5 CLEANING
FILTERS AND
FILTER-HOLDERS
Place two spoonfuls of special cleanser in half a
litre of hot water and immerse filter and fil-
ter-holder (without its handle) in it leaving them
to soak for at least half an hour. Then rinse
abundantly with running water.
6.6

CHANGE WATER

To prevent the concentration of salts dissolved
in the steam boiler becomes excessive, it is
recommended to provide a daily pickup of at
least 4-5 cups of water.
WARNING