Using Steam (Manual Steam Wand); Making Cappuccino; Hot Water Selection - Victoria Arduino VA358 White Eagle Manuel D'instructions

4.3 USING STEAM
(Manual steam
wand)
NOTE: The use of the steam wand must
always be preceded (done before) the
cleaning out of the condensation for at
least 2 seconds.
CAUTION
RISK OF BURNS OR SCALDING
While using the steam nozzle, you must pay
attention to not place your hands beneath it
or touch just after it has been used.
To use the steam function, pull or push the rel-
evant lever, as shown in the figure.
By pulling it completely the lever will hold a
position of maximum delivery; by pushing it, the
lever will automatically give way.
The two steam nozzles are articulated to guar-
antee their easy use.
4.4 MAKING
CAPPUCCINO
To obtain the typical cappuccino foam, immerse
the nozzle all the way into a container 1/3 full of
milk (preferably cone-shaped). Turn on the
steam. Before the milk starts to boil, pull the
nozzle slightly up and lightly move it vertically
across the surface of the milk. When you have
50
completed the procedure, clean the nozzle
carefully with a soft cloth.
4.5 HOT WATER
SELECTION
RISK OF BURNS OR SCALDING
While using the hot water nozzle, pay care-
ful attention not to place your hands beneath
it or touch it just after it has been used.
This nozzle delivers hot water to make tea or
herb teas.
Place a suitable container under the hot water
nozzle. Press the hot water select button once;
the light will switch on.
The hot water wand will deliver water for the
Fig. 18
amount of time equivalent to the set value (see
PROGRAMMING section and the DOSE
PROGRAMMING section) or press the button
again to stop pouring.
NOTE: Hot water can be delivered at the same
time as coffee.
NOTE: The use of the hot water wand must
Fig. 19
CAUTION
always be preceded by the purge of the
hydraulic circuit for at least 2 seconds.