Victoria Arduino VA358 White Eagle Manuel D'instructions page 34

The appliance must not be installed
where it may be used water jets.
At the end of installation, the device is
switched on and taken to rated operat-
ing conditions, leaving it in a state in
which it is "ready for operation".
After reaching the "ready for operation"
condition, the following dispensing
operations are carried out:
• 100% of the coffee circuit through
the coffee dispenser (for more
than one dispenser, this is divided
equally);
• Open the steam outlet for 1 minute.
At the end of installation, it is good prac-
tice to draw up a report of the operations.
The maximum and minimum storage
temperatures must fall within a range of
[+5, +50]°C.
The operating temperature must be
within the range of [+5, +30]°C.
The coffee machine must not be left
switched on without supervision, i. e.
without the presence of an operator.
Simonelli Group is not responsible for
any damage caused by malfunction of
the machine, in case this machine is left
on without the presence of the operator.
WARNING
Before using the machine, read this man-
ual in its entirety or, at the very least,
read the safety and set up instructions.
There are some basic rules for the use
of any electrical appliance.
In particular:
34
• Never touch the unit with wet
hands or feet;
• Never use the unit with bare feet;
• Never use extension cords in areas
equipped with baths or showers;
• Never pull on the power supply
cord to unplug the unit;
• Never leave the unit exposed to
atmospheric agents (rain, direct
sunlight, etc..);
• Never let children, unauthorized
personnel or anyone who has not
read this manual operate the unit.
Before performing any sort of mainte-
nance, the authorized technician must
turn off the unit and unplug it from the
mains.
OK
Before cleaning the unit set it in a state
of "0" energy: that is, "MACHINE
SWITCHED OFF AND UNPLUGGED".
Follow the instructions given in this
manual carefully.
Refer to chapters 6 and 7 for periodical
cleaning and maintenance.
OK
In case of breakdown or poor function,
turn off the unit. Never tamper with the
unit. Contact only professionally quali-
fied personnel. Only the manufacturer or
an authorized service center can make
repairs and only using original spare
parts.
Non compliance with the above can
compromise machine safety.
On installation, the qualified electrician
must fit a circuit breaker switch as fore-
seen by the safety norms in force that
has a contact open distance that permits
the complete disconnection under con-
ditions of overload category III.
To prevent dangerous overheating, it is
advisable to fully extend the power sup-
ply cord.
Never block the intake and/or heat dissi-
pation grills, in particular those for the
cup warmer.