Deactivating The Automatic Switch-Off Function; Troubleshooting - VOLTCRAFT VC-10D Notice D'emploi

When embracing the conductor, make sure the conductor is
positioned in the center of the flexible current sensor (5). Any
other position will most likely increase the risk of incorrect
measurements (measuring error).
The following table shows the error tolerances to be added and
the respective distances to the center. The "+" icon in the sketch
represents the center.
Distance VC-10D (25 cm)
field
Distance
A 15 mm
B 25 mm
C 35 mm
d) Deactivating the automatic switch-off function
The product turns off automatically after 20 minutes of inactivity in order to save energy. It is possible to
deactivate this function.
• Switch on the product by pressing and holding the
• While the display (1) shows the battery capacity ("FULL", "HALF" or "LO"), press the light button (3). "AoFF"
appears in the display, indicating that the automatic switch-off function has been deactivated.
• Continue using the product as usual and switch it off manually after use.

8. TROUBLESHOOTING

Error
The product does not work.
All repairs other than those described here may be carried out by an authorized professional only.
If you have any questions regarding the use of this product, please contact out technical customer
service for help.
VC-18D (45 cm)
Error Distance
±2 % 35 mm
±2.5 % 50 mm
±3 % 60 mm
/Hold button (2) for 2 seconds.
Possible cause
The batteries are used up.
The product is not switched
on.
Error
±1 %
±1.5 %
±2 %
Possible solution
Check the battery capacity. Replace the
batteries.
Press and hold the
2 seconds.
A B C
/Hold button (2) for
21