Troubleshooting - Parkside Pbhs 650 A1 Instructions De Fonctionnement Et De Sécurité

16. Troubleshooting

Fault Possible cause
Hedge trimmer does not •
run •
•
•
•
•
Hedge trimmer cuts with •
interruptions
•
Motor runs, cutting device •
remains stationary •
•
Cutting device gets hot •
•
14
GB/IE/NI/CY/MT
Engine, no fuel
Fault in the fuel line
Fuel filter clogged
Spark plug defective
Carburettor defective
Internal fault
Internal fault
On/off switch defective
Cutting device blocked
Internal fault
Clutch defective
No lubrication → friction
Cutting device is blunt
Remedy
• Check the fuel quantity
• Check the fuel line for kinks or damage
• Clean or replace the fuel filter.
• Replace spark plug
• Contact the manufacturer or the responsible
customer service centre
• Contact the manufacturer or the responsible
customer service centre
• Contact the manufacturer or the responsible
customer service centre
• Contact the manufacturer or the responsible
customer service centre
• Remove object
• Contact the manufacturer or the responsible
customer service centre
• Contact the manufacturer or the responsible
customer service centre
• Oiling the cutting device
• Have the cutting device sharpened