Create Studio Combi Pro 402 Manuel D'utilisation page 19

Remove the refrigerator door.
1. Unscrew the screws on the upper hinge cover and then re-
move it.
2. Install the communication cable into the junction box on
the top of the refrigerator.
3. Unscrew the three screws on the top hinge, then remove
the hinge.
4. Unscrew the screw on the lid from the left-hand hole in the
top of the refrigerator, then remove the lid.
5. Unscrew the two bolts and one screw securing the cen-
tre hinge, remove the centre hinge and then remove the
freezer door.
6. Remove the lid, screw and hole plug from the left side of
the refrigerator and install them on the right side.
7. Unscrew the screw on the trim strip cover and remove the trim strip cover.
8. Unscrew the two door stop screws at the bottom of the refrigerator door and freezer door res-
pectively, and remove the door stops.
Dismantle the lower hinge and adjustable foot assembly.
1. Remove the three screws securing the lower hinge assem-
bly and disassemble the lower hinge assembly.
2. Remove the adjustable left foot.
Remove the lower hinge assembly.
1. Disassemble the lower hinge: Successively remove the fixings and the pin shafts from the lower
hinge assembly.
2. Fit the lower hinge: Rotate the fixing 180° and reinstall it, install the pin shaft in the right-hand
side of the lower hinge plate (the hole symmetrical to the original pin shaft hole). This will allow
you to mount the lower hinge.
CHANGE DOOR DIRECTION
Fastener
Screw
Shaft
Washer
Hinge shaft
Adjustable foot
Fastener
E NG LI SH 19