Eurosystems MZP07 Mode D'emploi page 19

TROUBLESHOOTING
FAULT
The engine does not start
The engine power goes down
The tines are not rotating
In case you are not able to remedy the defect/damage according to a.m. table, please contact an authorized service center only .
F o r w a r d
reverse drive label
Read the instructions manual
before operating on the machine
- Danger tiller rotation
Before performing any maintenance and clearing work operation , please take the spark-plug cap off.!
FAULT CLEARANCE
Check the fuel level, if necessary refuel.
Check the throttle to be on START position.
Check the spark-plug connector to be properly attacched.
Check the spark-plug condition and if necessary replace it.
Check the fuel valve to be in the opened position( only for the models showing
such feature).
The air filter is dirty – please clean it.
Check if any stone or soil/vegetation residue is stopping the tines rotation, in case
clean them.
Adjust the transmission cables registers.
Check the tines to be fasten to the shaft.
a n d
Sticker handlebar rotation
1.
Manufacturer
1
2.
Model: xxxx-xxxxxxxxxxx
2
3.
Type: xxxxx xxxx | xxxxxxxxxxxx
3
8
4.
Nr.: xxxxxxxxx-xxxxxx
4
5.
Weight: xxx kg
5
Date: aaaa / E
6 6.
Power: x.xx kW
7
7.
8.
Label accelerator
Manufacturer identification
Model
Product identification code
Item serial number
Mass
Year / Month
Motor power
Type of product
19
EN