Troubleshooting - Scheppach wox d 700sl Mode D'emploi

Troubleshooting

1. Brake board defect
Upon switching off
the saw does not
.
slow down
Saw blade comes loose 1.
after the engine is
turned off.
Burnt areas on the 1.
cutting surface 2.
Engine does not start 1.
2.
3.
4.
5.
6.
7.
The engine runs irre- 1.
gularly. 2.
3.
4.
5.
6.
7.
The engine has over- 1.
heated. 2.
3.
4.
Electrotechnical maintenance works should only be carried out by an electronics technician!
On removal of the machine the local legal regulations have to be abided by.
Seite:42
Mounting nut has not been sufficiently tightened. 1.
Blunt saw blade
Incorrect saw blade
The spark plug cable has been disconnected.
No fuel or old fuel.
The choke is not in the open position
The fuel line is blocked.
Dirty spark plug.
The engine has stalled.
The engine oil level is low.
The spark plug cable is loose.
The engine runs with CHOKE.
The fuel line is blocked or old fuel is in the tank.
The ventilation hole is blocked.
There is water or contamination in the fuel
system.
Dirty air filter.
Incorrect carburettor setting.
The engine oil level is low.
Dirty air filter.
The air flow is restricted.
The carburettor is not set correctly.
1. Renew brake board
Tighten the mounting nut; right-hand thread.
1. Sharpen the saw blade, replace it.
2. Replace the saw blade
1. Connect the spark plug cable securely to the
spark plug
2. Put in clean, fresh petrol.
3. The throttle lever has to be in the CHOKE
position during cold start.
4. Clean the fuel line.
5. Clean, set gap or replace.
6. Wait a few minutes before restarting, but do not
let the engine draw in petrol.
7. The oil monitor prevents the engine starting if
the oil level is low - check the oil level.
1. Connect the spark plug cable and secure it.
2. Turn the choke lever to OFF.
3. Clean the fuel line. Fill the tank with clean,
fresh petrol.
4. Clear the ventilation hole.
5. Empty the tank. Fill the tank with fresh fuel..
6. Clean or replace the air filter.
7. Contact the Service Department.
1. Fill the crankcase with the correct oil.
2. Clean the air filter.
3. Remove the casing and clean it.
4. Contact the Service Department