Dell PowerEdge R660 Manuel D'installation Et De Maintenance page 98

Figure 44. Configuration 15: 10 x 2.5 inch (SAS/SATA) + 2 x 2.5 inch (SAS/SATA) (fPERC12)
NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse sequential
order.
Table 92. 10 x 2.5 inch (SAS/SATA) + 2 x 2.5 inch (SAS/SATA) (fPERC12)
Order From
1 SIG_PWR_1 (system board power
connector)
2 SL3_CPU1_PA2 (signal connector on system
board)
3 CTRL_SRC_SA1 (fPERC controller
connector)
4 SL4_CPU1_PB2 (signal connector on system
board)
5 SIG_PWR_0 (system board power
connector)
6 CTRL_SRC_SB1 (front PERC controller
connector)
98 Disassembly and reassembly
To
BP_PWR_1 (backplane power connector)
CTRL_DST_PA1 (fPERC input connector)
BP_DST_SA1 (backplane signal connector)
CTRL_DST_PB1 (fPERC input connector)
R_BP_PWR_1 (rear backplane power connector)
R_BP_DST_SA1 (rear backplane signal connector)