Dell PowerEdge R660 Manuel D'installation Et De Maintenance page 88

Figure 34. Configuration 5: 10 x2.5 (NVMe) + 2 x 2.5 (NVMe)
NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse sequential
order.
Table 82. 10 x2.5 (NVMe) + 2 x 2.5 (NVMe)
Order From
1 SIG_PWR_1 (system board power
connector)
2 SL1_CPU2_PA1 (signal connector on
system board)
3 SL2_CPU2_PB1 (signal connector on
system board)
4 SL5_CPU2_PB3 (signal connector on
system board)
5 SL3_CPU1_PA2 (signal connector on
system board)
6 SL11_CPU1_PB7 (signal connector on
system board)
7 SIG_PWR_0 (system board power
connector)
8 SL4_CPU1_PB2 (signal connector on
system board)
88 Disassembly and reassembly
To
BP_PWR_1 (backplane power connector)
BP_DST_PA1 (backplane signal connector)
BP_DST_PB1 (backplane signal connector)
BP_DST_PA2 (backplane signal connector)
BP_DST_PB2 (backplane signal connector)
BP_DST_PA1 (backplane signal connector)
R_BP_PWR_1 (rear backplane power connector)
BP_DST_PA3 (backplane signal connector)