Dell PowerEdge R660 Manuel D'installation Et De Maintenance page 93

Figure 39. Configuration 10: 10 x 2.5 inch (SAS/SATA) (fPERC 12)
NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse sequential
order.
Table 87. 10 x 2.5 inch (SAS/SATA) (fPERC 12)
Order From
1 SIG_PWR_1 (system board power
connector)
2 SL3_CPU1_PA2 (signal connector on
system board)
3 CTRL_SRC_SB1 (front PERC controller
connector)
4 CTRL_SRC_SA1_PA1 (fPERC controller
connector)
5 SL4_CPU1_PB2 (signal connector on
system board)
To
BP_PWR_1 (backplane power connector)
CTRL_DST_PA1 (fPERC input connector)
BP_DST_SB1 (backplane signal connector) and R_BP_DST_SA1
(rear backplane signal connector)
BP_DST_SA1 (backplane signal connector)
CTRL_DST_PB1 (fPERC input connector)
Disassembly and reassembly 93