Dell PowerEdge R660 Manuel D'installation Et De Maintenance page 105

Figure 51. Configuration 22: 10 x 2.5 inch NVMe + 2 x EDSFF E3.S x 4 NVMe
NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse sequential
order.
Table 99. 10 x 2.5 inch NVMe + 2 x EDSFF E3.S x 4 NVMe
Order From
1 SIG_PWR_1 (system board power
connector)
2 SL1_CPU2_PA1 (signal connector on
system board)
3 SL2_CPU2_PB1 (signal connector on
system board)
4 SL3_CPU1_PA2 (signal connector on
system board)
5 SL4_CPU1_PB2 (signal connector on
system board)
6 SL7_CPU1_PB4 (signal connector on
system board)
7 SIG_PWR_0 (system board power
connector)
8 SL11_CPU1_PB7 (signal connector on
system board)
To
BP_PWR_1 (backplane power connector)
BP_DST_PA1 (backplane signal connector)
BP_DST_PB1 (backplane signal connector)
BP_DST_PA2 ( (backplane signal connector)
BP_DST_PB2 (backplane signal connector)
BP_DST_PA3 (backplane signal connector)
R_BP_PWR_1 (rear backplane power connector)
R_BP_DST_PA1 (rear backplane signal connector)
Disassembly and reassembly 105