Dell PowerEdge R660 Manuel D'installation Et De Maintenance page 87

Figure 33. Configuration 4: 8 x 2.5 inch (NVMe) (Min Config)
NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse sequential
order.
Table 81. 8 x 2.5 inch (NVMe) (Min Config)
Order From
1 SIG_PWR_1 (system board power
connector)
2 SL1_CPU2_PA1 (signal connector on
system board)
3 SL2_CPU2_PB1 (signal connector on
system board)
4 SL3_CPU1_PA2 (signal connector on
system board)
5 SL4_CPU1_PB2 (signal connector on
system board)
To
BP_PWR_1 (backplane power connector)
BP_DST_PA1 (backplane signal connector)
BP_DST_PB1 (backplane signal connector)
BP_DST_PA2 (backplane signal connector)
BP_DST_PB2 (backplane signal connector)
Disassembly and reassembly 87