To Adjust The Skid Shoe; Lubrication; Blade Scraper And Skid Shoes; Fuel Recommendation - Meec Tools 029194 Instructions D'utilisation

2
Clear away snow and ice with the clearing tool.
3
Put back the clearing tool in the holder and start the
engine. Stand in the driving position behind the
handle and engage the auger for a few seconds to
throw out any residual snow and ice from the ejector
chute.

5.3 To adjust the skid shoe

1
Loosen the 4 flange lock nuts and the screws.
2
Move the skid shoes to the applicable position.
3
Make sure that the undersides of the skid shoes rest
on the ground along the whole of their length, to
avoid uneven wear.
4
Tighten the screws.

5.4 Lubrication

Lubricate different parts of the product regularly to keep the
product in good condition.
5.4.1 Drive and gear mechanism
● Lubricate once a year, or after every 25 working hours.
● Remove the rear cover and lubricate the bearings, shafts
and gear components once a year with engine oil or
lubricating spray.
5.4.2 Gear linkage
Caution! Keep the tires and aluminium belt pulleys
free from grease and oil.
● Lubricate the gear linkage with a applicable grease once
a year or after every 25 working hours.
5.4.3 Control for ejection angle
● Lubricate the worm gear to set the ejection angle with a
applicable grease.
5.4.4 Gearbox
Caution! Do not overfill the gearbox, this can damage
the seal. Check that the vent plug is free from grease
● The gearbox is lubricated at the factory and does not
need any maintenance.
● If it needs to be dismantled for any reason, fill up the
gearbox with 60 ml lithium grease for high performance.
Before reinstalling the gearbox, remove the old seal and
replace with a new one.
5.4.5 Auger bearings
● Lubricate the auger bearings and the bearings on the
side of the frame with a thin oil once every season.
5.4.6 Auger shaft
● The shear pins on the auger shaft should be removed at
least once every season. Spray lubricant in the shaft and
lubricate the plastic bearings in the auger at least every
season.
5.4.7 Drive and gear mechanism
● Lubricate once a year, or after every 25 working hours.
● Remove the rear cover and lubricate the chains,
sprockets, bearings, shafts and gear components at least
once per season with engine oil or lubricating spray.
5.4.8 Control handle, ejector unit
● Lubricate the worm gear to set the ejection angle with a
suitable grease.

5.5 Blade scraper and skid shoes

● Do a check if the blade scraper and skid shoes are worn,
replace if necessary.

5.6 Fuel recommendation

Caution! Do not use E85.
● Use unleaded petrol with a rating of at least 87 octane.
● Petrol with at most 10% ethanol or 15% MTBE (methyl
tertiary butyl ether) can be used.
● Do not use old, contaminated fuel or fuel mixed with oil.
Avoid getting water and debris in the fuel tank.

5.7 To drain the fuel tank

Let the engine operate until the fuel tank is empty.

5.8 To refill the fuel

Warning! Be very careful when handling fuel. Petrol
is highly flammable and can in some circumstances be
explosive.
● Do not refuel indoors or when the engine operates. Refill
the fuel in a well-ventilated area with the engine stopped.
19