Personal Protective Equipment; Assembly; To Assemble The Product; Operation - Meec Tools 029194 Instructions D'utilisation

● Let the product become cool for at least 5 minutes before
you store it.
● Make sure that all screws are correctly tightened.

2.6 Personal protective equipment

Warning! If you do not obey these instructions, there
is a risk of death or injury.
● Always wear non-slip shoes.
● Wear approved safety glasses or a visor. The product can
eject objects that can cause permanent eye injuries.
● Wear gloves that are not electrically conductive.
● Wear sufficient winter clothes.
● Wear ear protection.
3

Assembly

3.1 To assemble the product

Note! References to the left and right side is when the user
is standing in the driving position behind the product.
1
Remove the plastic covering parts of the product and
unpack all loose parts. Store the shear pins in a safe
place.
2
Connect the lever wires as shown in the illustration.
(Figure 2)
3
Attach the top and bottom handle with the locking
bolts and tighten them. (Figure 3)
4
Attach the connecting rod for the angle adjustment
crank. (Figure 4)
5
Install the deflector chute and tighten all bolts.
(Figure 5 and 6)
6
Install the skid shoes on both sides of the auger
housing. (Figure 7)
7
Adjust the skid shoes to an applicable height if
needed before the bolts are tightened. (Figure 8)
4

Operation

Warning! Do not leave the product unattended when
engine is in operation.

4.1 To do before the operation

Caution! Products with electric starter motors must
only be connected to earthed power outlets.
● Inspect the area where the product is to be used and
remove any stones, wires, or other foreign objects.
● Do a check of the product before use. Make sure that all
screws are correctly tightened before the operation. Do
not use the product if the safety devices are damaged.
● Ejected objects can cause serious personal injury. Plan
the work so that materials are not thrown towards roads,
bystanders or other places.
● Wear personal protective equipment when you operate
with the product.
● Adjust the height of the skid shoes so that the the auger
housing do not scrape the ground.
● Before you start the engine; disengage and put all the
controls in neutral mode.
● Do not make any adjustments while the engine operates.
● Let the engine adjust to the outdoor temperature before
you start to clear the snow.

4.2 Training

Warning! Do not allow children to operate the
product!
Warning! Keep the area clear of bystanders, specially
small children and pets. Stop the product if anyone enters
the work area.
● Read all the instructions and safety instructions and all
the warning labels on the product prior to assembly and
use. Save these instructions for future reference.
● Familiarize yourself with the controls on the product and
how to use them. Learn how to stop the product quickly
and how to disengage the drive.
● Make sure to take caution during operation to avoid
accidents, specially when you walk backwards.
● Ejected objects can cause serious personal injury. Plan
the work so that materials are not thrown towards roads
and bystanders.
15