Behaviour Without Dmx Signal; Making A Reference Move; Functional Test; Showing System Information - IMG STAGELINE WASH-50LED Mode D'emploi

red
green
blue
4) Set the maximum value desired (125 – 255)
for the colour selected and then press ENTER
to save it .
If required, repeat steps 3 and 4 for the other
primary colours .

9.5 Behaviour without DMX signal

Proceed as follows to define if the spotlight is
to switch off the light when no DMX signal is
available or if the spotlight is to change to the
automatic mode:
1) Call up the menu with the button MENU .
2) Select the menu item
 or  and then press ENTER to confirm .
The display will indicate the current setting .
3) Use the button  or  to define if the spot-
light is to switch the light off (
DMX signal is available or if the spotlight is
to change to the automatic mode (
press ENTER to save the setting .

9.6 Making a reference move

When the spotlight head has been manual-
ly misadjusted during operation or when its
movement has been obstructed, the reference
move (which is automatically made every time
the power supply is switched on) should be re-
peated .
1) Call up the menu with the button MENU .
2) Select the menu item
 or  .
3) Press the button ENTER . The reference move
will be made and
display .

9.7 Functional test

A test program can be started for the functional
test .
1) Call up the menu with the button MENU .
2) Select the menu item
 or  .
3) Press the button ENTER . The test program
will be carried out and the display will start
flashing .
20
with the button
) when no
); then
with the button
will appear on the
with the button
4) To exit the test program, press the button
ENTER or MENU .

9.8 Showing system information

1) Call up the menu with the button MENU .
2) Select the menu item
 or  and then press ENTER to confirm .
3) Use the button  or  to select the infor-
mation desired and then call it up with the
button ENTER .
operating hours
version of the unit firmware
temperature inside the unit (in °C)
4) Press the button ENTER and then proceed
with step 3 to show a different type of in-
formation .

10 Cleaning the Unit

Clean the plastic pane at regular intervals de-
pending on impurities . This is the only way to
ensure that light will be emitted at maximum
brightness . Before cleaning, disconnect the
mains plug from the socket. Only use a soft,
clean cloth and a mild detergent .
For cleaning the other parts of the hous-
ing, only use a dry, soft cloth . Never use fluids
or chemicals; they may leak into the unit and
damage it .

11 Specifications

Data protocol: . . . . . . . . . . DMX 512
Number of DMX channels: . 1, 9 or 16
Connections: . . . . . . . . . . . XLR, 3 poles
Light source: . . . . . . . . . . . 4 × 15 W RGBW LED
Beam angle: . . . . . . . . . . . 8°
Pan range: . . . . . . . . . . . . . 540°
Tilt range: . . . . . . . . . . . . . 180°
Power supply: . . . . . . . . . . 230 V~ / 50 Hz
Power consumption: . . . . . 60 VA max.
Remote control battery: . . . 3 V lithium button cell,
Ambient temperature: . . . . 0 – 40° C
Dimensions: . . . . . . . . . . . 160 × 130 × 240 mm
Weight: . . . . . . . . . . . . . . . 3.4 kg
with the button
type CR 2025