Infeed And Outfeed Tables (Optional Accessory); Dust Collection; Installing Abrasives - Jet JWDS-1632-M Mode D'emploi

5. Position sander atop stand so that the four
threaded holes of base align with holes in the
stand rails (Figure 6).
6. Fasten base to stand (from beneath) with the four
screws and washers that you removed from the
plywood boards. Tighten screws securely.
6.5 Infeed and outfeed tables (optional
accessory)
The sander must be bolted to the stand or a work table
when using these table extensions. Maximum working
load of each table is 16kg. Fasteners are provided with
the extension tables.
1. Install infeed and outfeed brackets (L, Figure 6-3)
to the threaded holes in sander base with M8x16
socket head cap screws and flat washers. Make
sure left and right brackets are oriented as shown.
The brackets should be flush against the base.
NOTE: Long brackets mount to front (infeed);
short brackets to rear (outfeed).
2. Place extension tables over brackets and secure
with M8x12 socket head cap screws and washers.
Finger tighten only.
3. Position tables slightly below conveyor belt
surface for proper support of stock. To check
position, place a straight-edge on one side of
conveyor table under drum and extending out
over the extension table. Lower drum to securely
hold straight-edge in place. See Figure 6-4. Raise
infeed/outfeed table until table surface is slightly
below conveyor belt surface. Tighten screws on
that side.
4. Reposition straight-edge to other side of table
and repeat.
If stock being sanded is bowed, warped or otherwise
inconsistent, be sure tables are lower than top of
conveyor table.
If stock slips on conveyor, the tables may be positioned
too high. Lower tables to allow stock to remain in
contact with conveyor.
Figure 6-4: extension table alignment

6.6 Dust collection

Dust collection is mandatory for a safe work
environment and extended abrasive life. The JWDS-
1632-M is equipped with a 100mm dust collection
port. Secure a 100mm dust collection hose to the port
with a hose clamp (Figure 6-5), and connect to a high
volume dust collector (minimum 560m3/h).
Figure 6-5 (hose and clamp not included)

6.7 Installing abrasives

Proper attachment of the abrasive strip to the drum is
critical to achieving top performance from your drum
sander.
An 80-grit, 76mm wide abrasive strip is pre-installed
on the drum.
(TIP: If you are using an after-market abrasive, use a
new JET-supplied abrasive as a template to quickly cut
a new strip. Press fastener lever (Figure 6-7) on
outboard (left) end of drum, and insert tapered end of
abrasive through slit in fastener, as shown. Insert
approximately 75mm of abrasive strip into fastener.
Align tapered edge of abrasive strip with left edge of
drum.
1. Release fastener lever to secure end of strip.
2. Begin wrapping abrasive around drum. The
tapered edge of strip end should follow as close
as possible to edge of drum.
3. Continue to wrap abrasive in spiral fashion by
rotating drum with one hand and guiding strip
with the other. See Figure 6-8.
10
Figure 6-7