Setup And Assembly; Shipping Contents; Tools Required For Assembly - Jet JWDS-1632-M Mode D'emploi

6.0 Setup and assembly

Open boxes and check for shipping damage. Report
any damage immediately to your distributor and
shipping agent. Do not discard any shipping material
until the Drum Sander is assembled and running
properly.
Compare the contents of your boxes with the following
parts list to make sure all parts are intact. Any missing
parts should be reported to your distributor. Read this
instruction manual thoroughly
maintenance and safety instructions.

6.1 Shipping contents

Box #1: (see Figure 6-1)
1 Sander with conveyor table (A)
1 Handle (B)
1 Instruction manual (not shown)
1 Spare parts list (not shown)
Box #2: (see Figure 6-2)
1 Stand assembly including:
1 Shelf (C)
2 Short rails (D)
2 Long rails (E)
4 Legs (F)
4 Leveling feet (G)
8 Flat washers (H)
4 Hex nuts (I)
24 Carriage Bolts, M8x16 (J)
24 Flanged Lock Nuts, M8 (K)

6.2 Tools required for assembly

12mm and 14mm wrenches
3mm and 6mm hex wrenches
Straight edge (such as straight steel bar or carefully
jointed board)
Figure 6-1: box #1 (main unit)
for assembly,
8
Figure 6-2: box #2 (stand assembly)