Jet JWDS-1632-M Mode D'emploi page 18

properly, only bottom lip of tracker will be visible.
The top slot can be used if bottom slot wears out.
8. Install second tracker opposite the first. Use both
trackers unless the second one does not fit in
conveyor or unless conveyor belt is damaged.
9. Turn conveyor table right-side up and reposition
it onto sander. Re-attach three mounting screws
and tighten. Caution: Be careful not to knock
tracker(s) out of conveyor table when turning
conveyor over. Trackers may break if allowed to
fall.
10. Make sure all switches are off. Connect power to
sander and plug in motor.
11. Tension conveyor belt using take-up screws. If
both trackers are installed, it is very important to
have equal tension on both sides of conveyor belt.
Turn take-up screws on both sides until equal
tension is obtained.
Tracker
Tracker
Figure 11-1: Underside of conveyor shown
18
12. To check tension, turn on conveyor full speed and
place both hands on conveyor. If conveyor belt
can be stopped, continue tensioning until
conveyor belt cannot be stopped by both hands
on the belt while conveyor is operating at full
speed.
13. Make sure conveyor belt runs smoothly inside
tracker slot and that the magnet is holding the
tracker in position.
14. Continue to watch tracking of conveyor and
adjust only if necessary, making sure to keep
equal tension on conveyor belt at all times and
not allowing conveyor belt to buckle under
conveyor table.
Driven roller
Conveyor belt